O-Ring Mod Kit - IN-STOCK

The O-Ring Mod Kit is a great addition to any tray mount case purchase. Use this kit in your next keyboard build to add a more cushioned typing feel and better acoustics. 

To Install:

1. Make sure standoffs are installed on the case. When using this o-ring mod kit, please make sure that the shorter standoffs from this kit are used, instead of the 4mm high standoffs that are included with each case.*
2. Place one o-ring on top of each standoff. 
3. Next, place the PCB into the case. 
4. Slip one o-ring onto each of the screws. 
5. Finally, insert the screws through the mounting holes on the PCB and into the standoffs, securing the PCB to the case. The PCB should now be sandwiched between the two o-rings. 

Note: 

• *Added x6 shorter 3mm high standoffs to kit, to account for increased height when using o-rings. This was done after receiving feedback that PCB module was sitting too high above the top lip of the case after o-rings were installed.